Emetteur Recepteur HF 433.MHz AUREL
De MicElectroLinGenMet.
Sommaire |
Emetteur TX-433-SAW
Voir exemple d'utilisation: Generation signaux X10-RF avec un AVR
Brochage
1 GROUND 2 Modulation Input with Vc > 8 V 3 Modulation input with Vc < 8 V 4 GROUND 11 ANTENNA OUTPUT 13 GROUND 15 Vc from +4V to +12V
Spécification
- High reliability hybrid circuit
- Work frequency: 433,92 Mhz obtained by SAW resonator
- 10mW RF. output (+0 .. -2 dB) with 50 Ohm antenna (5 V)
- Spuries - 60 dB respect to the fundamental
- Modulation frequency 4 Khz max 5 V logics
- + 5 V R.F. supply with typical absorption of 3,5mA with square wave modulation
- Thick film S.I.L. module with dimension 12,2 x 38,1 x 6 mn; Pins pitch 2,54 mn (0,100")
Récepteur RF 290 A-5S
Brochage
1 +5V 2 GROUND 3 ANTENNA 7 GROUND 10 +5V 11 GROUND 13 TEST POINT 14 OUT 15 +5V ... +24V
Specification
- High reliability hybrid circuit
- Available frequency: from 220 to 433 Mhz
- R.F. sensibility measured with input ON - OFF signal better of 2,24 uV [- 100 dBm] in band center
- RT. pass-band at -3 dB >= +/-2Mhz
- Antenna lambda/4
- Square wave output with max frequency of 2 Khz
- + 5 V R.F. supply with typical max absorption of 5 mA. L.F. supply variable from + 5 V Up to + 24 V (typical absorption 2 mA), correspondent logic output
- Thick Film S.I.L. module with dimension 16,5 x 38,1 mm ; pins pitch 2,54 mn (0,100')
- Custom design: on request
- Available model with high slew-rate and output pass-band (RF 290 A5S - F)
